Cutting Technique; Chip Box; Transporting The Premium Super Dry Cutter - Jepson 9435 T3 Mode D'emploi

6.3 Cutting technique

Step 1: The circular cold saw can cut at angles of 45°-90°.
a) For 90°, position the work piece between the clamping plate and the set-
ting up piece and ensure that the clamping fixture is tightened with the
clamping handle in clockwise direction.
b) For 45°, loosen the screw at the setting up piece, set the machine to the
desired angle and re-tighten screws.
Next, insert the work piece and tighten the clamping fixture firmly.
Step 2: On the handle, there is a safety switch (Figure 10). Follow steps 1, 2 and 3.
Ensure that the motor runs load free for a few seconds to reach the maximum opera-
ting speed before you start sawing.
Step 3: Cut slowly and evenly. Lift the handle off the work piece and release the
switch to switch off the saw. Release the handle only after the saw blade comes to a
total standstill.

6.4 Chip box

The chip box (Figure 11) catches up to 80% of the chips.

6.5 Transporting the Premium Super Dry Cutter

If you want to transport the Premium Super Dry Cutter machine, keep the stopper
handle (Figure 12) pulled outward and lower the operating arm to the lowest posi-
tion. Now let the stopper handle engage.
You can now transport the device with the handle.
11
26