Installation Instructions; Installation Preparation; Positioning The Appliance; About Power Connection - Danby DDW611W Guide D'utilisation

Installation Instructions

INSTALLATION
PREPARATION
POSITIONING
THE APPLIANCE
ABOUT POWER
CONNECTION
The installation position of the dishwasher should be near the exist-
ing inlet and drain hoses and power cord. One side of the cabinet
sink should be chosen to facilitate the connection of drain hoses of
the dishwasher.
Position the appliance in the desired location on the counter top.
Make sure the unit is level and is close enough to electrical and water
hook ups.
For personal safety:
• DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG
WITH THIS APPLIANCE.
• DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE THE
GROUNDING CONNECTION FROM THE POWER CORD.
ELECTRICAL REQUIREMENTS
Please look at the rating label to know the rating voltage and connect the
dishwasher to the appropriate power supply. Use the required fuse 15
amp, time delay fuse or circuit breaker recommended and provide sepa-
rate circuit serving only for this appliance.
ELECTRICAL CONNECTION
Ensure the voltage and frequency of the power being corresponds to
those on the rating plate. Only insert the plug into an electrical socket
which is grounded properly. If the electrical socket to which the appliance-
must be connected is not appropriate for the plug:
• Have the socket replaced by a qualified professional.
• Avoid using adaptors because they could cause overheating and
burns.
Insure proper ground exists before use!
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of a malfunction or break-
down, grounding will reduce the risk of electric shock by providing a path
of least resistant electric current. This appliance is equipped with
a cord that has an equipment-grounding conductor and a grouding plug.
The plug must be plugged into an appropriate outlet that is installed and
grounded in accordance with all local standards and requirements.
• Improper connection of the equipment grounding conductor can
result in the risk of an electric shock.
• Check with a qualified electrician or service representative if you
are in doubt as to whether the appliance is properly grounded.
• Do not modify the plug provided with the appliance. If the plug
does not fit properly to the outlet, please have a qualified
electrician install a proper outlet.
14
WARNING
WARNING
WARNING