Publicité
Les langues disponibles
Les langues disponibles
Fig. 13
4. Remove lower blade spacer, lower
insulator washer and blade (Figure 14)
5. When replacing sharpened or new
blade on shoulder of fan, make sure
cutting edges of the blade are closest
to the ground. Place lower insulator
washer over shoulder of the fan. Now
place lower blade spacer and the
blade nut on the shaft.
NOTE: Align flats of shaft with flats in
lower insulator washer and lower the
blade spacer.
Position wood to keep shaft from
turning (Figure 13) and then securely
tighten blade nut.
Fig. 14
BLADE NUT
LOWER
LOWER
BLADE
INSULATOR
SPACER
WASHER
LOWER
INSULATOR
WASHER
BLADE
ARMATURE
SHAFT
All manuals and user guides at all-guides.com
Lubrication
No lubrication is necessary. Do not oil the
wheels. They have plastic bearing
surfaces which require no lubrication.
Cleaning
TURN OFF, LET THE BLADE COME TO
A STOP AND THEN UNPLUG MOWER!
Use only mild soap and a damp cloth to
clean the mower. Clean out any clippings
which may have accumulated on the
underside of the deck. After several uses,
check all exposed fasteners for tightness.
PREVENTING CORROSION
Fertilizers and other garden chemicals
contain agents which greatly accelerate
the corrosion of metals. If you mow in
areas where fertilizers or chemicals have
been used, the mower should be cleaned
immediately afterward as follows: (1) Be
sure the tool is turned off and unplugged.
(2) Wipe all exposed parts with a damp
cloth.
CAUTION: DO NOT POUR OR SPRAY
WATER ON THE MOWER IN AN
ATTEMPT TO CLEAN IT.
do not store the tool on or adjacent to
fertilizers or chemicals. Such storage can
cause rapid corrosion.
Storage
Your mower should be stored in a dry
place.
8
Publicité
