AEG AX3 Serie Instructions D'emploi page 8

Change the fan speed by gently touching fan icon
on the product. If the product is in AUTO mode, it
will switch to manual mode on touching the fan
icon. (ref. picture 7).
Auto mode and sleep mode
8
Change between AUTO and SLEEP mode by
gently touch icon labeled "
In AUTO mode the unit will adjust operation
according to latest air quality (PM2.5 level). In
SLEEP mode unit will operate at the low noise
level and all indicators except for SLEEP icon will
go off.
Power off
9
Power down the product by gently touching the
ON/OFF icon on the center of the product
(ref. picture 9)
AIR QUALITY INDICATOR
The appliance has an air quality sensor that
10
analyzes the air quality.
The air quality light will show the real-time air
quality through different colors of light. As shown
below:
LIGHT'S COLOR PM 2.5 (μg/m
Green 0-12
Yellow 13-35
Orange 36-55
Red >56
FILTER CHANGE INDICATOR
The filter change indicator will light up to
11
remind you to change the filter (Ref. # AFFBRZ2).
• When filter change indicator flicker with red
light, please replace the filter and reset the filter
change indicator.
• When filter change indicator stop flicker and the
red light fix, please replace the filter immediately
and reset the filter change indicator.
Filter change indicator reset operation
12
Press the mode icon labeled "
filter change indicator will reset, then red
light will go off.
8
".
) AIR QUALITY
3
Very Good
Good
Poor
Bad
" for 3s and
CARE AND CLEANING
Unplug the appliance before cleaning to prevent
13
shock or fire hazards. Use a damp cloth or a
vacuum cleaner with soft brush to clean your air
purifier.
The plastic part of the cabinet and top may be
14
cleaned with an oil-free cloth or washed with a
cloth dampened in a solution of warm water and
mild liquid dishwashing detergent. Be sure to
wring excess water from the cloth before wiping
around the controls. Excess water in or around
the controls may cause damage to the appliance.
15 Never use harsh cleaners, wax or polish when
cleaning the unit.
STORAGE
If you are not planning to use the appliance for
16
a long time, cover it with plastic or return it to its
carton.
NOTE: The multi-layer filter can not be washed, it
can only be replaced.
CAUTION!
Do not touch the fan blade when removing the
multi-layer filter.
ERROR CODE
Fan failure error code, when fan failure occurs, the
17
light of screen will all go off and the unit can't be
operated then.
Air quality sensor failure error code, when sensor
18
failure occurs, the light of air quality indicator will
go off and the unit can't be set on auto mode.
GB
www.aeg.com