Publicité
Les langues disponibles
Les langues disponibles
DIODE MEASUREMENT
1. Connect red lead to "V Ω mA" jack, black leads to
"COM" jack.
2. Set switch to
3. Connect the red test lead to the anode of the diode
to be
4. The forward voltage drop in mV will be displayed. If
the diode is reserved, figure "1" will be shown.
BATTERY AND FUSE REPLACEMENT
Fuse rarely needs replacement and will blow almost
always as a result of an operating error. If
appears on the display, it indicates that the battery
should be replaced. To replace the battery and fuse
(250mA/600V, 10A/600V) remove the two screws at
the bottom of the case. Simply remove the old and
replace with a new one. Be careful to observe polarity.
CAUTION Before attempting to open the case of the
instrument, be sure to disconnect test leads from any
energized circuits to avoid shock hazard.
78207i.indd 10
position.
measured and black test lead to cathode.
WEEE AND END OF LIFE DISPOSAL
This marking indicates that this product should
not be disposed with other household wastes
throughout the EU. To return your used device,
please use the local return and collection
systems or contact the retailer where the
product was purchased.
02-04-19 14:0
Publicité
