Siemens SIMATIC HMI Mobile Panel 277 IWLAN Instructions De Service page 361

EC Declaration of Conformity
The EC Declaration of Conformity is available for the responsible authorities according to the above-mentioned EC Directive
at the following address:
Siemens Aktiengesellschaft
Automation & Drives
A&D AS RD ST
PO Box 1963
D-92209 Amberg, Germany
This declaration certifies compliance with the directives named above, but does not guarantee any specific properties.
To download information on the EC Declaration of Conformity, go to http://support.automation.siemens.com.
UL approval
Underwriters Laboratories Inc., to
● UL 508 (Industrial Control Equipment)
● CSA C22.2 No. 142 (Process Control Equipment)
The approval is only valid in the case of battery operation or when stationary in the charging station.
FCC approval
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications made to this equipment not expressly approved by SIEMENS may void the FCC authorization to
operate this equipment.
Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
This device has been shown to be capable of compliance for localized specific absorption rate (SAR) for uncontrolled
environment / general public exposure limits specific in ANSI/IEEE C95.1-1992 and had been tested in accordance with the
measurement procedures specified in IEEE Std. 1528-2003 December 2003.
IC approval Canada
Exposure to Radio Frequency (RF) Signals:
The wireless device is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission limit for
exposure to radio frequency (RF) energy set by the Ministry of Health (Canada), Safety Code 6. These limits are part of
comprehensive guidelines and established permitted levels of RF energy for the general population. These guidelines are
based on the safety standards previously set by international standard bodies. These standards include a substantial safety
margin designed to assure the safety of all persons, regardless of age and health.
This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
This device has been shown to be capable of compliance for localized specific absorption rate (SAR) for uncontrolled
environment / general public exposure limits specific in ANSI/IEEE C95.1-1992 and had been tested in accordance with the
measurement procedures specified in IEEE Std. 1528-2003.
Mobile Panel 277 IWLAN, Mobile Panel 277F IWLAN
5
A5E01004934-02, 10/2008