Unit Packaging, Transport And Reception; Unit Installation - ITV ICE MAKERS R290 Mode D'emploi

1.2 UNIT PACKAGING, TRANSPORT AND RECEPTION

The packaging protects the unit against possible damage during transport. All the material used are environmentally-friendly and can
be recycled or reused.
The unit is palletised and wrapped in a wooden structure. It should be transported, stored and unloaded in the position: ALWAYS
HORIZONTAL. If this is not the case, the unit should be left standing for a few hours before operation in order to allow the compressor
oil to settle.
Check that the packaging has not been damaged during transport. If damage is present, make a claim with the transport company
or agency that provided the transport service IMMEDIATELY (no damaged units may be returned without reporting the damage and
without authorisation after resolving this situation with the transport agency).
Cut the transport strips and remove any plastic and cardboard, taking care with any wood staples or splinters. Do not mark or strike
the unit with the tools used for unpacking. Always leave the transport pallet until last.

1.3 UNIT INSTALLATION

Move the unit with a pallet jack to the position where it will be installed. Carefully remove the pallet cover so as not to damage the unit.
Then remove all the protective elements from the unit (cork, film, etc.).
Do not place the unit in the sun, near any heat sources or near any hot air vents.
Leave enough free space around the unit where the air vents are located and do not cover these vents, so that hot air can be vented
without obstruction.
5