Optima LOVENS EXPLORER Manuel De L'utilisateur page 10

9. Close the loop connectors with the
caps.
EN
Figure 8 - Closing loop connectors.
10. Open the caps on the top of the two
adapters
here.
Figure 9 - Opening caps for adapters.
WARNING
• If you do not use the rain cover, it is
important to close the openings on the
adapters. This ensures that children's
fingers cannot become trapped.
11. Slide the
adapters until they cannot move any
further.
12. Take the fabric with rods and attach
the rod assembly to the
in the Lovens Explorer.
Figure 10 - Attaching the rods.
10
❽
. The rods can be inserted
❸
angled rods into the
❸
angled rods
⓬
13. Attach the press connectors on the
front of the bike to the fixing points in
the fabric.
Figure 11 - Attaching press connectors front side.
PLEASE NOTE
• Ensure that the press connectors on
the front are properly closed. If the
press connectors are not attached or
closed properly, hazardous situations
may arise.
Figure 12 - Correct position press connectors.
14. Attach the loop at the rear to the loop
connector to close the rain cover.
15. The Velcro strip may also be attached
around the frame at the side of the
bike.
❽
Figure 13 - Attaching the loop to the loop connectors.