Troubleshooting - Nikon WT-2 Mode D'emploi

Troubleshooting

Problem
"POWER" LED does not light.
All LEDs blink at once.
Wireless LAN option not avail-
able in camera setup menu.
Excessive radio interference.
Camera displays wireless, TCP /
IP, or FTP error.
Can not connect to ftp server.
Transfer interrupted before all
photographs are sent.
50
• Turn camera on.
• Press shutter-release button halfway to acti-
vate exposure meters.
• Select On for Wireless LAN > Wireless
LAN system option in camera setup menu.
• Reattach WT-2.
WT-2 hardware error. Contact a Nikon-autho-
rized service representative.
Select PTP for USB option in camera setup
menu.
Change orientation of camera or antenna.
Check settings for host and / or wireless LAN
adapter and adjust camera settings appropri-
ately.
Check settings for server and / or wireless LAN
adapter and adjust camera settings as described
in "Sample ftp Settings."
Transfer will resume if camera is turned off and
then on again, exposure meters are reactivated,
or On for Wireless LAN > Wireless LAN sys-
tem option in camera setup menu.
Solution
5
—
24
4
—
5
—
26
28
32
42
11