Custom Features - Amana ADW662EAB Manuel Du Propriétaire

Custom Features

If These Features are
Different from Yours
These features are intended to
show the variety that is available
in the product line. If your dishwasher
does not have all the options that are
shown, it is not a mistake. The
information provided applies to several
of the models in the product line.
Indicator
Lights
The CLEAN light illuminates at the
end of the cycle and remains lit until
the door has been open for 30
seconds continuously.
The DRY light illuminates during the
entire dry period and goes out when
the cycle is completed.
The WASH light illuminates during all
rinse and wash portions of the cycle.
The HEATING PAUSE light
illuminates when the cycle is being
extended to heat the water.
Sensor Clean
Amana recommended
cycle choice for all
day-to-day soil types.
Normal dishloads vary from day to
day. Sensor clean is recommended
because it selects the number of fills
and wash time best suited for the soil
level of each load. Depending on the
number of fills required water usage
ranges from 4 to 10 gallons.
Drain/Off
To drain the dishwasher
and then turn it off, press
Drain/Off once. Press
Drain/Off twice to turn the dishwasher
off without draining.

Delay/Resume
The Delay/Resume option can be used to automatically start the
cycle at a later time, such as during off-peak hours for reduced
energy cost or to reduce daytime heat buildup in the home.
To set up a delay:
1. Select the appropriate cycle and options for the load.
2. Press the Delay/Resume pad until the desired amount of delay time
is selected. The delay time will begin counting down when the pad is
released.
3. The Delay/Resume indicator light will remain lit until the delay time has
counted down.
4. The cycle will automatically start as soon as the delay time expires.
NOTE: If Delay/Resume is chosen without selecting a cycle and/or options,
the dishwasher will select the last cycle used. (It will not remember
the Rinse Only cycle.)
Control Lock Option
The control touchpads can be locked to prevent unwanted use. If
this feature is activated between cycles, the dishwasher cannot
be operated until the controls are unlocked. If desired, the
controls can be locked after a cycle or delay has started.
NOTE: This option does not lock the door, only the dishwasher controls.
Setting the control lock:
1.Press the pad for three seconds.
2.An indicator light above the pad will illuminate when the controls are
locked.
To cancel:
1.Press the pad for three seconds.
2.The indicator light will go off.
NOTE: If a cycle or option pad is pressed after the controls have been
locked, the indicator light above the Control Lock pad will flash five
times.
High Temp Wash
Use High Temp Wash when washing loads with hard-to-remove food
soils. High Temp Wash can be selected with any cycle, except
Rinse Only. Depending on which cycle is being used, selecting
High Temp Wash adds fills, heat and/or wash time to the wash cycle.
For baked-on, dried-on soils, select Pots and Pans along with High Temp
Wash option. The use of an enzyme detergent is recommended
High Temp Rinse
High Temp Rinse provides a water temperature check in the main
wash and also in the final rinse cycle. If necessary, the heating
element will turn on and the cycle will be extended to heat water to
the proper temperature.
Select High Temp Rinse with any cycle (except Rinse Only) to assure proper
hot water temperature and to enhance drying results.
6