Gartenmeister GM AAS 4025 Mode D'emploi page 26

Composition des scies à chaînes
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

A kickback is the result of a wrong or improper
use of the power tool. It may be avoided by tak-
ing the following proper precautions:
• Hold the saw with both hands with the
thumbs and fingers firmly embracing the
handles of the chain saw. Position your
body and arms such that you can with-
stand the power of a kickback. When prop-
er precautions are taken the operator will be
able to control the power of a kickback. Never
let go of the chain saw!
• Avoid unusual postures and do not cut
above shoulder height. This avoids acci-
dentally touching objects with the tip of the
bar and allows for a better control of the chain
saw in unexpected situations.
• Only use the replacement bars and chains
prescribed by the manufacturer. The use of
wrong replacement bars and chains may lead
to chain breaks or kickbacks.
• Adhere to the manufacturer's instructions
to sharpen and maintain the chain. Depth
limiters that are too low increase the risk of
a kickback.
• Set the loop so that it is not detected dur-
ing operation of branches or the like.
9) Important instructions for your personal
safety
A) General safety instructions
1. Never attempt to use an incomplete machine
or one which an unauthorised alteration has
been implemented.
2. These devices are not designed to be op-
erated by persons who have insufficient ex-
perience and/or insufficient knowledge or by
persons with impaired physical, sensory or
mental capabilities, unless they are being su-
pervised by a person who is responsible for
their safety or they are receiving instructions
about how these devices are to be used.
3. Children and young persons under 18 may
not operate electrical chainsaws, with the
exception of apprentices older than 16 under
the supervision of a trained adult.
4. The chainsaw may only be used by persons
who have sufficient experience.
5. Always keep these Operating Instructions
together with the chainsaw.
6. Only lend or give this chainsaw to persons
who are familiar with its use. Also give them
these Operating Instructions.
GB | Operating Instructions
B) Instructions on using the chain saw safely
7. Attention! Read the Operating Instructions
8. Always store your electric tools in a safe
9. Always hold the chain saw with both hands
10. The chain saw must be disconnected from
11. During work breaks put the machine down in
12. When switching on the chain saw, ensure
13. The chain saw may only be used in a com-
14. Switch the chain saw off immediately if you
15. Always have a first-aid kit fulfilling DIN 13164
16. If the chain saw comes into contact with
17. Ensure that no chain oil penetrates into the
18. Avoid to use the trimmer in poor weather
C) Warning to the danger of recoil ("kickback")
19. If possible, use a stand.
20. Always keep an eye on the bar tip.
21. Only place a running saw on the object to be
22. So called piercing cuts with the bar tip may
D) Instructions on safe working techniques
23. Working on ladders, scaffoldings or trees is
7
carefully and have yourself instructed in the
use of a chain saw before you use it for the
first time.
place. Electric tools not being used should
be stored in a dry, inaccessible or locked
place, outside the reach of children.
while working with it.
the power supply before you tighten the
chain, exchange the chain or carry out any
other work on the saw. - Remove the rechar-
geable battery!
such a manner that nobody is at risk. Remo-
ve the rechargeable battery.
that it is supported well and hold it firmly. The
chain and bar must be free.
pletely assembled state. No protective devic-
es may be missing.
notice any changes in the machine.
at hand in case of accidents.
earth, stones, nails or other foreign objects,
withdraw the plug immediately and check the
chain as well as the bar.
earth or sewage. Always place the chain saw
on something that will absorb any oil dripping
from the bar or chain.
conditions, especially if there is a risk of a
thunderstorm.
cut. Never start the machine while the chain
rests on something.
only be carried out by trained personnel.
forbidden.

Publicité

Table des Matières
loading

Table des Matières