Publicité
Les langues disponibles
Les langues disponibles
Install the front cover and top case on the bottom case.
Two mounting tabs are at the top of the top case. (A cover is already installed on the case at the time of factory shipment.)
Hook those two tabs onto the bottom case, and click the top case into place. Check that the case is securely installed and not lifted.
■ Direct wall installation (when running the cable along the wall)
remote controller.
Installation is complete.
Follow the instructions below when uninstalling them.
t cover and top case
Uninstalling the front cover
Insert a flat-tip screwdriver or a Plate service
tool into either of the two latches at the bottom
of the remote controller, and move it in the
direction of the arrow as shown in the figure at
right. Note that the top case may also be
removed if the driver or the tool is inserted
deeply.
Uninstalling the top case
Insert a flat-tip screwdriver or a Plate service
tool into either of the two latches at the bottom
of the remote controller, and move it in the
direction of the arrow as shown in the figure at
right.
Important
To prevent damage to the control board, do not insert
the driver into the slot strongly.
Installing the cover and top case
Two mounting tabs are at the top of the top case.
Hook those two tabs onto the bottom case, and
click the top case into place.
Install the cover on the top case in the same way
as with the top case.
Check that the top case is securely installed and
not lifted.
cess hole at the top of the
Wall
Top case
Wall
No lifting
Use a cable cover.
Thread the cable through the
top of the remote controller.
or
or
Wall
Wall
No lifting
Front cover
Top case
15
Publicité
