Wittkopp Basic Manuel D'utilisation page 15

2. Master- or user code
2.1 Changing the master and user code
Make sure that the safe door is open when you change the code. Key in a six digit code (or factory code 123456
if you use the lock for the first time).
Step
Press and hold the '0' button until the red light stays on
1.
Key in the code (or factory code 123456 for the first time)
2.
Enter a new code, for example 567891
3.
Repeat the new code, for example 567891
4.
(the red light goes out)
If the new code is not accepted, you hear a long signal. In that case, start again at step 1 for changing the code.
After changing the code, it is best to test the new code several times with the door open.
2.2 Setting the user code
Make sure that the safe door is open when you change the code (key in the master code).
Step
1. Press and hold the '1' button until the red light stays on
2. Key in the master code, for example 567891
3. Key in new user code, for example 111111
Repeat the new user code, for example 111111
4.
(the red light goes out)
If the new code is not accepted, you hear a long signal. In that case, start again at step 1 for changing the user
code. After changing the code, it is best to test the new code several times with the door open.
2.3 Deleting user
Step
1. Press and hold the '3' button until the red light stays on
Key in the master code, for example 567891
2.
(the red light goes out)
The user code has been deleted. Only the master code remains valid. If the user code deletion is unsuccessful,
you hear a long signal. In that case, start again at step 1 for deleting the user code.
Action
Action
Action
Key
0
123456
567891
567891
Key
1
567891
111111
111111
Key
3
567891
15