Publicité
Les langues disponibles
Les langues disponibles
Instruction of Assembly
14. After mounting of net, put a cord in the lower net edge and fix it at ring nuts. Fix net in the lower part of net hoops
with plastic holders (3 units per hoop).
15. To store the goals, loose and fold net hoop brace. Screw fixing wheels into the nuts being in the middle of the crossbar
so that they cannot be lost. Remove ground tubes and fold net hoops.
16. The goals have to be anchored on the hall floor. Therefore a corresponding boring (Pos.11) is installed in each hoop.
Attention
The nets have to correspond to EN standard 749. The goal can only be used for handball and not for other purposes. Before
use check if all connections are fixed and repeat this later again and again. At any time the goal has to be protected against
tipping. Do not climb on net or goal frame.
Additional remark for:
Indoor handball goals with
„folding net hoops"
„for insertion in ground sockets"
Cat.no. 11 203 4515
Upright's length (inside dimension) is 2300mm = insertion depth 300 mm. For mounting of screws (Pos. 4) use lengthened
hexagon socket screw key.
When concreting the ground sockets do not apply an acceleration mixture or antifreeze, as these adhesives may cause damages
to the sockets.
1
5
4
3
2
6
11
12
13
Art.-Nr. 11 201 0902
11 201 0944
11 201 0957
11 203 4515
9
2 = upright
10
3 = system net holder (German Registered Patent)
8
4 = steel corner connection
6 = net hoop hinge
7
8 = net hoop brace
9 = boring for net hoop brace
10 = boring for net supporting device-top
11
11 = boring for goal anchoring according
12
13
12 = boring for net supporting device-bottom
13 = boring to take up ground tube
14 = ground tube
14
15 = screw socket for ground tube
Schulsport · Vereinssport · Fitness · Therapie
1 = crossbar
5 = net hoop supporting angle
7 = net hoop
to German Industry Standards
5
Publicité
