Publicité
Les langues disponibles
Les langues disponibles
Instruction of Assembly
1. Stick 1 aluminium nut, thread M 8, length 40 mm in each crossbar's end.
2. Stick steel plates (see photo) on the steel angle and stick complete steel corner connection (4) into the crossbar.
Then mount uprights.
3. Lay superior net hoop supporting angle (5) on crossbar/upright construction (so that the boreholes of the angle are upon the
holes of crossbar/upright construction) and fi x it with 4 safety hexagonal socket screws M 8x50 each.
4. Lay lower net hoop hinge (6) on the upright. Stick 4 safety hexagon socket screws M 8x14 from the inside of the upright with
a hexagon socket screw key and screw nuts M 8. Adjust hinge and tighten all screws.
5. Stick caps in the uprights and bore them with drill 1,5 mm through borings being in the uprights. Then fi x guide pins.
6. Mount 1 ring nut each with self-locking nut M 8 into the net hoop borings (Pos.10 and 12).
7. Stick hexagon socket screw M 8x45 through boring of net hoop (Pos.9), screw and tighten self-locking nut M 8.
8. Push net hoop brace (8) on net hoops.
9. Stick net hoops (7) in the hings parts and tighten above with hexagon socket screw M 8x50 and below with flat head screw
M 8x50 and self locking nuts M 8.
10. Erect net hoops, lay brace on crossbar, push nut below boring of brace and screw in hand wheel.
11. Stick machine screw M 8x90 through screw socket (Pos.15) and push these units in ground tube (Pos.14), so that the borings
in the screw socket and in the ground tube are lying upon another. Then screw and tighten machine screw M 8x12.
12. Screw ground tube (14) between the net hoops (in borings Pos. 13), screw and tighten wing nuts M 8.
13. Mount net holders at the net and distribute them equally:
Crossbar: 16 pieces Uprights: 8 pieces
a) Bend up the net holders, press a cord into the ring.
b) After mounting of all net holders, fi x net at the goal construction. Please consider that there is a free hanging net between the
hoops and that it is not drawn over the hoops.Stick net holders in the net hook rail (also in the big holes of the upper net hoop
holding angles and of the lower net hoop hinges) and fi x them by rotation through 90°. In case use for this a thin screw driver.
Stick it through the ring and turn net holders by 90°.
c) Dismantling of the net is also done by rotation of the net holders through 90°. In case use again a thin screw driver.
Art.-Nr. 11 201 0902
11 201 0944
11 201 0957
11 203 4515
Schulsport · Vereinssport · Fitness · Therapie
M 8
4
Publicité
