hawa Concepta 25 Instructions De Conception Et De Montage page 6

1 Table of contents
Contents
1 Table of contents
2 Product information
3 Safety instructions
4 Abbreviations, symbols
5 Overviews
6 Planning
7 Calculation
8 Pre-assembly
9 Assembly
10 Disassembling
6
5.1 Overview: Left-hand system
5.2 Overview: Connector 55 (optional)
5.3 Overview: Connector 110 with and without base (optional)
5.4 Overview: Two inset pivot sliding doors
5.5 Overview: Position numbers
6.1 Planning: Inset doors
6.2 Planning: Guide for two pivot sliding doors
6.3 Planning: Doors closing against base and top section with Connector 55
6.4 Planning: Doors closing against base and top section with Connector 110
6.5 Planning: Doors in wall recess
7.1 Calculation: Door weight/height ratio
7.2 Calculation: Plan view dimensions
7.3 Calculation: Hardware depth
7.4 Calculation: Drill hole positions
8.1 Pre-assembly: Processing the left side profiles
8.2 Pre-assembly: Processing the right side profiles
8.3 Pre-assembly: Doors
8.4 Pre-assembly: Cabinet side
8.5 Pre-assembly: Outside pocket wall
8.6 Pre-assembly: Dampener
8.7 Pre-assembly: Upright
8.8 Pre-assembly: Aligning the cabinet
9.1 Assembly: Scissor and upright installation, left-hand system
9.2 Assembly: Scissor and upright, right-hand system
9.3 Assembly: Door
9.4 Assembly: Door closing system
9.5 Assembly: Fine adjustment of door upright angle 19 - 30 mm
9.6 Assembly: Fine adjustment of door upright angle 31 - 50 mm
9.7 Assembly: Positioning the stop dampener
9.8 Assembly: Door height adjustment
9.9 Assembly: Door clearance gap fine adjustment
9.10 Assembly: Door clearance fine adjustment
9.11 Assembly: Fine adjustment of doors
9.12 Assembly: Fine adjustment pull-in speed
10.1 Disassembly: Door closing system for fixed outside panel
Page
6
7
7
10
13
14
15
16
17
18
19
20
21
22
23
25
27
28
30
31
32
33
35
36
37
38
39
42
45
46
48
49
50
52
53
54
55
56
57