HoMedics Brethe AR-NC01 Manuel D'instructions Et Renseignements Concernant La Garantie page 8

TABS TABS
Fig. 19
Fig. 20
Clean Filter Indicator
This air cleaner is equipped with a CLEAN FILTER indicator to let you know when it
is time to clean the Nano-Coil filter, about every 732 hours of use. When the Nano-
Coil filter is ready to be cleaned, the CLEAN FILTER indicator will light up on the
control panel.
Once the Nano-Coil filter has been cleaned, press and hold the CLEAN FILTER button
until it beeps to reset the filter indicator.
We recommend replacing your VOC filter, if you choose to use it, when you replace
your Nano-Coil filter (about every 18 months, with regular maintenance).
To purchase a Nano-Coil replacement filter, model # AR-NCFL1, go back to the retailer
(where you purchased your air cleaner) or visit www.homedics.com. Replacement
VOC filter, model # PP-ARNC01VOC, can also be purchased
at www.homedics.com.
8. Place the tabs at the bottom of the
grill plate into the base of the unit.
See Fig. 19
9. Hold engaged bottom of the grill
plate in place and push the top of the
grill plate back toward the unit until
the release tabs at the top of the grill
click back into place. See Fig. 20
1 4
Cleaning and Maintenance
We recommend that the air cleaner be cleaned at least once a month and before storage.
1. Turn the air cleaner OFF and unplug it from the outlet
2. Use a dry cloth to clean the external surfaces of the air cleaner
3. The grill plate may be cleaned with a damp cloth or the brush attachment of
your vacuum cleaner.
DO NOT USE WATER, WAX, POLISH, OR ANY CHEMICAL SOLUTION
Troubleshooting
Problem Possible Cause
The unit won't • The unit is not
turn on plugged in
• Nano-coil filter is
incorrectly installed or
out of place
• Rear cover is not
completely attached
• Remote control battery
has run down
• The front or rear grill is
No air flow or
blocked by foreign objects
noticeable
cleaning effect
• The plastic bag is still on
the VOC/Odor filter
• The filters are dirty
• The unit has been running
for over 2,000 hours
Solution
• Plug the unit in
• Properly install the
nano-coil filter
• Make sure rear grill is
completely engaged
• Replace the battery
• Remove any obstacles
or check the pre-filter
and clean if needed
• Remove the plastic bag
• Clean or replace the
nano-coil filter and/
or clean the pre-filter
• Replace the
nano-coil filter
1 5