Spektrum FAT SHARK SPMVR2520 Manuel D'utilisation page 8

Video Receiver Module
Receiver Power Switch: The receiver
module power is independently
controlled from the small switch on the
bottom of the headset. If a module is
inserted, but the desired video source
is via the AV cable or HDMI cable, the
receiver module must be turned off to
avoid image confl ict.
Receiver Display Button: A small button next to the display on the receiver controls
the frequency analyzer, band selection and channel auto-select.
Channel
Band
RSSI Indicator
Selecting Band
1. Press and hold the receiver display button for a moment to enter the analyzer mode
and to change bands. The video receiver display will show a frequency analyzer and
sweep through all the channels on the band, showing each channel's signal strength. It
will continue to cycle through the frequencies until you press the button again.
2. A short press will enable you to change to the next band and then sweep through
the channels on that band to show signal strength.
3. Select the current band by pressing and holding the receiver display button for a
moment. Use the Headset channel control buttons on the top of the headset to
change to a specifi c channel within the selected band.
Selecting Channel
1. Press and release the receiver display button to enter channel auto-select. The
receiver will sweep the selected band and select the strongest channel.
2. The channel selection buttons on top of the headset enable you to take manual
control of channel selection at any time. The headset emits an audio beep upon
changing the channel. A long beep sounds at the high and low channel limits and
no change will take place.
3. The headset will remain on the last channel in use after a power cycle.
All manuals and user guides at all-guides.com
Receiver Module Display
F7
5860
8
Frequency
Receiver
Display
Button