Spektrum FAT SHARK SPMVR2520 Manuel D'utilisation page 6

Controls
Brightness and contrast control: Pressing the 5-way video display control left
increases the display contrast, pressing right will decrease contrast. Pressing forward
will increase brightness and pressing back will decrease brightness.
Display mode selection: Press down vertically on the 5-way video display control to
sequence through the following modes: Analog 16:9, Analog 4:3, Analog 3D, HDMI 2D,
and HDMI 3D.
Low battery warning: The headset will emit increasingly frequent audio warning
beeps if the input voltage drops below 6.8V. If the low voltage warning begins while
fl ying, land immediately. If the voltage warning is ignored, the headset will eventually
shut off and stop displaying the video signal.
Volume control: Each press of the button steps the volume up or down.
AV Output/Input: The same connector is used for either video input or output. It will
operate as an output if the cable is connected to an external monitor. To use as an
input, connect the cable to an analog video source. Ensure the video receiver module is
powered off and the DVR is not in playback mode.
IPD Adjustment: Adjust the sliders for optimal alignment.
®
Mini HDMI Input
The Mini HDMI port can be
connected to HDMI devices
by using an HDMI cable with
a Mini HDMI connector or
Mini HDMI adaptor.
1. Connect an HDMI cable
to the HDMI device and
the headset.
2. Power on the video source.
3. Power on the headset.
Disconnect the battery when
switching between devices to
clear the settings.
The video receiver module needs to be powered off or removed when operating in
HDMI mode for proper operation.
Tip: Most HDMI connectivity issues are due to either incorrect display settings at the
video source, or a faulty HDMI cable. Before assuming the HDMI feature is defective, try
with alternative HDMI sources and alternative cables. HDMI cables may fracture over
time at connector fl ex points.
All manuals and user guides at all-guides.com
6
HIGH-DEFINITION MULTIMEDIA INTERFACE
®