Publicité
Les langues disponibles
Les langues disponibles
ON/OFF button
Press the ON/OFF button to turn the apparatus on or off. When the apparatus is turned on, the
display will show the current humidity percentage, the ventilator speed will be set to 'medium',
and the apparatus will humidify continuously (this is without setting the target humidity
percentage).
Illumination / Sleep Mode button
Using this button, the light intensity of the control panel can be adjusted and the apparatus can
be turned on of off in sleep mode.
By consecutively pressing this button you can set the following:
Position 1 - Dimmed light
Position 2 - Normal light
Position 3 - Bright light
Position 4 - Turns on sleep mode. The corresponding symbol lights up.
In sleep mode, the ventilator speed is automatically set to 1 (low) and the
illumination of the control panel is switched off.
You cannot use the humidity percentage setting button in sleep mode.
The other buttons can be used. If you press the AUTO button, sleep mode will be
switched off.
Position 5 - Turns off sleep mode. The corresponding symbol will be off.
The apparatus will return to the default settings: ventilator speed on 2 and
humidifying continuously (this is without setting the target humidity percentage).
AUTO button
If you press the AUTO button, the apparatus will keep the humidity on the ideal level of 50%.
(This means that the apparatus will not operate when the humidity in the room is above 50%!)
Humidity Percentage Setting button
Use this button to set the desired humidity percentage. The display shows the set humidity
percentage for a few seconds and subsequently the currently measured humidity percentage.
The humidity can be set to between 40% and 75%.
As soon as the desired humidity level is reached the apparatus will stop operating. When the
humidity drops below the set value, the apparatus will resume its operation.
If you select 'CO' (continuously), the apparatus will operate continuously i.e., without stopping.
Timer button
Press the Timer button to set the desired operating time. Press this button a few times to set the
number of hours (1 – 12 hours). The display shows the remaining time.
Ventilator Speed button
Use this button to set the desired ventilator speed:
1 – Low, 2 – Medium, 3 – High, 4 – Turbo
Low water level
The display shows two flashing lines when the water level in the water tank is too low. The
ventilator will continue to rotate for a number of hours to dry the apparatus and will then stop
working automatically.
In normal mode, the ventilator will continue to operate for 7 hours in position 2 to dry the
apparatus. In the sleep mode, the ventilator will continue to operate for 10 hours in position 1 to
dry the apparatus. The display will continue to show the flashing lines while the ventilator is
drying the apparatus.
26
Publicité
