Wall Mounting - Soler&Palau RADIANT-1500 Manuel D'installation

- The product must be positioned in such a way that the power supply socket can always be reached.
- This appliance must not be used connected to a programmer, timer or another device that controls
heater connection automatically.
3. SAFE POSITIONING
- Only use the equipment in a horizontal position.
- If used as a portable unit, always respect the minimum distances from any inflammable object indi-
cated in figure 2.
- For wall mounting respect the minimum distances from the ceiling, floor, and side walls shown in
figure 3.
- In bathrooms never install or use the equipment within zones 0 or 1 shown in figure 4.
- The regulating knobs must never be accessible to people in a bath or shower.
- The product must be free to take air in and expel it.
- For portable use:
• Assemble the pedestal by screwing the rod (figure 1/D) to the base (figure 1/C) with the 2 coun-
tersunk screws supplied (fig 5).
• Insert the pedestal rod in the relevant rectangular slot that can be seen in the lower grille on the
product (figure 6).
• Fix the pedestal to the product using the 4 screws supplied at the points indicated in figure 7.
- This product has double electrical insulation and does not require an earth connection.
4. WALL MOUNTING
- The product can be wall mounted only if the pedestal is not fitted and respecting the distances shown
in figure 3.
- Screw the product to the lower support bracket as shown in figure 8 using the screws supplied.
- Fix the wall bracket by making 2 holes in the wall 150 mm apart, using a 6 mm drill bit. Insert the 2
wall anchors and fix the wall bracket using the 2 screws supplied as shown in figure 9.
- Hook the product to the wall bracket first pushing it towards the wall and then making it click in
downwards (figure 10).
- Use a pencil to mark the point at which to drill the hole for fixing the lower support, remove the pro-
duct, drill the hole in the wall using a 6 mm drill bit, and insert the wall anchor supplied (fig 11).
- Hook the product to the plastic bracket again and fix the lower bracket using the relevant screws.
- IMPORTANT FOR FRANCE:
If the product is to be wall mounted the electrical connection to the power supply must be done by
cutting off the plug supplied and using a suitable terminal as per the diagram shown below:
Electricity
In wet spaces like bathrooms or kitchens, the connection terminal must be installed at least 25 cm abo-
ve the floor. The electrical connection to the power supply must also be fitted with a two-pole switch
with a minimum gap between the contacts that allows complete disconnection according to excess
voltage III category conditions.
Phase = brown
Neutral = blue
10
Product's cable