Placement Of The Water Pump System For Home Use - Renkforce 1519512 Mode D'emploi

7. Placement of the water pump system for home use

• The pump can be set up and operated, e.g. near a well on your property or a rain water cistern.
• Set the water pump system for home use on a flat, level, stable and sufficiently large surface that is suitable for the
weight of the water pump system for home use with contained water. Protect sensitive surfaces from scratches,
pressure points and any escaping water with a suitable pad.
• Ensure that the pump of the water pump system for home use is higher than the surface of the water source from
which you want to collect water (e.g. well or rainwater cistern) if possible.
The water pump system for home use must always be operated standing upright, and never in any other
operating positions.
Due to the higher centre of gravity, we recommend screwing on the water pump system for home use via
the four openings in the feet (6). Use suitable screws and dowels for the surface. If the water pump system
for home use is not installed firmly, there is a risk of tipping. This not only poses a risk of damage to the
water pump system for home use and escaping of water, but also a danger of injury.
To reduce or avoid vibrations, you can use suitable vibration absorbers for attachment.
The water pump system for home use must be set up, installed and operated in a well-ventilated location
that is protected against the weather.
Never place the water pump system for home use in or under water; there is a danger to life from electric
shock! Never place the water pump system for home use in an area that may be flooded either. The water
pump system for home use must be installed and operated so that it cannot fall into the water.
• For outdoor temperatures at or below 0 °C, the water in the water pump system for home use will freeze and
destroy it. Loss of warranty/guarantee!
If the outdoor temperature is so low, first disconnect the water pump system for home use form the mains voltage
and then open a tap on the pressure side to drain the remaining water pressure. Then disconnect all hoses from the
water pump system for home use and drain the water pump system for home use and the hoses. Store the water
pump system for home use in a dry, clean and frost-free location.
• Only carry or move the water pump system for home use by the pressure storage tank. The water pump system for
home use must never be held or transported by the mains cable! This may damage the mains cable; there is danger
to life from electric shock! Never hold or move the water pump system for home use by the hoses or the pressure
switch either.
23