Publicité
Les langues disponibles
Les langues disponibles
Fax +32 030 9904733
• Please pay attention to the aspiration and dissipation air grids, in order to avoid obstructions, fire
risks or eventual device overheating. Please do not cover the device and do not use it to dry the
linen.
• Ensure that the fan works correctly: if this is not the case, switch off the appliance and have it
checked by professionally qualified personnel.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous and
render void the warranty.
• All repairs should be made by a competent qualified electrician. Any faulty appliances should be
returned to this service.
ASSEMBLY
In order to use the appliance it is necessary to assemble the two feet to the same; to do this act as
follows:
-
Always unplug the appliance before you assemble.
-
Lay the appliance down horizontally on a flat, smooth surface.
-
Position the feet by inserting the hooks into the slots provided in the inferior part of the
appliance and slide them in so that they engage.
-
Secure them with the screws provided.
DESCRIPTION OF THE APPLIANCE
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician
or a person with similar qualifications, in order to avoid any risk.
Attention: The appliance may only be used if complete with the feet.
To use the thermoconvector, please follow the instructions below:
1)
Insert the plug in the current socket.
2)
Turn the thermostat knob (3) clockwise in the position corresponding at the desired temperature.
3)
To turn on the appliance, turn the selector knob in the position corresponding at the function
requested.
"0" = off
"2000W" = air very hot (2000W)
4)
The light turns on and turns off when the appliance reaches the requested temperature.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
1.
Grid
2.
Light
3.
Thermostat knob
4.
Selector knob
5.
Fan grid
"1000W" = air warm (1000W)
"
" = air very hot (2000W) + fan
8
24
/
Assembly page 8/24
Publicité
