The First Wash Cycle; Technical Data - Indesit IWDC 6125 Mode D'emploi

Connecting the drain hose
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose and
must not exceed 150 cm in length.
Electrical connections
Before plugging the appliance into the electricity
socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the maximum
power load of the appliance as indicated in the
Technical data table (see opposite);
• the power supply voltage falls within the values
indicated in the Technical data table (see opposite);
• the socket is compatible with the plug of the
washing machine. If this is not the case, repla-
ce the socket or the plug.
! The washing machine must not be installed
outdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washing machine has been installed,
the electricity socket must be within easy reach.
Connect the drain
hose, without bending
it, to a drainage duct or
a wall drain located at a
height between 65 and
100 cm from the floor;
alternatively, rest it on
the side of a washba-
sin or bathtub, faste-
ning the duct supplied
to the tap (see figure).
The free end of the
hose should not be
underwater.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be replaced
by authorised technicians.
Warning! The company shall not be held responsible
in the event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before
you use it for the first time, run a wash cycle with
detergent and no laundry, using the wash cycle 2.

Technical data

Model IWDC 6125
width 59.5 cm
Dimensions height 85 cm
depth 53,5 cm
from 1 to 6 kg for the
wash programme;
Capacity
from 1 to 5 kg for the
drying programme
E l e c t r i c a l please refer to the technical
connections data plate fixed to the machine
maximum pressure 1 MPa
(10 bar)
Water con-
minimum pressure 0.05
nections
MPa (0.5 bar)
drum capacity 52 litres
up to 1200 rotations per
Spin speed
minute
Wash: programme 2; tem-
perature 60°C;
Energy
run with a load of 6 kg.
rated pro-
Drying: first drying cycle
grammes
performed with a 1 kg load,
according
by selecting a drying time of
to regula-
60 min;
tion
Second drying cycle perfor-
EN 50229
med with a 5 kg load and the
DRYING knob on the
This appliance conforms to
the following EC Directives:
- 89/336/EEC dated
03/05/89 (Electromagnetic
Compatibility) and subse-
quent modifications
- 2012/19/EU
- 2006/95/EC Low Voltage)
GB
setting.
3