Publicité
IMPORTANT
Please read these instructions carefully before you start to assemble this Product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
Care and Safety advice
Sort the parts and check against the content list.
For safety purposes we strongly recommend the product to be assembled
by at least two people.
Some parts have metal edges. Please be careful when handling components.
Always wear gloves, shoes and safety goggles during assembly.
Do not attempt to assemble the carport in windy or wet conditions.
Dispose of all plastic bags safely - keep them out of reach of small children.
Keep children away from the assembly area.
Do not attempt to assemble the carport if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
When using a stepladder or power tools, make sure that you are follow the
manufacturer's safety advice.
Do not climb or stand on the roof.
Heavy articles should not be leaned against the poles.
Please consult your local authorities if any permits are required to assemble
the carport.
Keep roof and gutters clean of snow, dirt & leaves.
Heavy amounts of snow on roof can damage the carport making it unsafe
to stand below or nearby.
This product was designed to be used as a carport mainly.
Some versions of this carport are painted.
If color was scratched during assembly it can be fixed with the following tints:
Gray - RAL 7016
Cleaning instructions
When your carport needs cleaning, use a mild detergent solution and rinse with
cold clean water.
Do not use acetone, abrasive cleaners, or others special detergents to clean the
panel.
Before Starting Assembly
This carport must be assembled on a solid base (such as concrete or asphalt).
Choose your site carefully before beginning assembly. Site surface
(mainly below poles) needs to be level.
During assembly use a soft platform below the parts to avoid scratches and
damages.
L
During Assembly
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
Step 7: 3 people needed to complete this step! Release the poles' upper screws in
Diagram A. Set the gutter in place and re -tighten the screws as shown in Diagram B.
Note the screws placement on the gutter.
Step 10: Repeat the actions as done in Steps 8 + 9
Step 22: Place the screws in where the panels indents and are overlapping
(Diagram A) and in the third indentation from the edge (Diagram B).
Step 23: Instructions similar to Step 20
Attention:
Peel the film covering the panel.
Make sure you install it with the UV protected side up (Steps 17+19)
Tighten all screws at the end of assembly.
Anchoring this product to the ground is essential to its stability and rigidity.
It is required to complete this stage in order for your warranty to be valid.
494.5cm / 194.7"
239 cm / 94.1"
287.5 cm / 113.2"
Do not tighten screws and nuts (8192 & 466) until completion of assembly process.
These 2 icons indicate if screws'tightening is required or not.
A.
466
Publicité
