Evolite EVO Spot 60 Mode D'emploi page 14

The main menu is accessed by pressing the Menu button, Browse through the submenu by
pressing Up or Down .Press the Enter-button in order to select the desired menu. You can change
the selection by pressing Up or Down, Confirm every selection by pressing the Enter-button. The
functions provided are described in the following setting.
Options
Run Mode DMX
AUTO
Random
Sound
DMX Address 1~512
Channel Mode Standard 12CH
Inversion Pan off
on
Inversion Tilt off
on
Pan-Tilt Swap off
on
Pan-Tilt Encoder on
off
No DMX Signal hold
clear
Display on
off
Load Default
EVO Spot 60 Manual Ver. 1.00
Description
Status of Slave: receive the DMX signal from the
main console or master
Status of Master：Auto Mode and send DMX
signal to slave
Press "OK" button into Edit Mode. Now the
hundred-bit is selected, press "UP","DOWN" to
change the address code. Press "OK" again to
choose the decade-bit to edit. Press "OK" once
again to choose the unit-bit, again to quit the Edit
Mode.
Standard 12 channel mode
Switch channels of Pan and Tilt axis(including
fine-tuning)
Use encoder (optocoupler) to estimate the wrong
step and right the wrong position
Don't use encoder (optocoupler) to right the
position
Keep going as this status
Motor return, stop running.
Turn off back light after being idle for 30 seconds
Back light always on
The Confirmation dialog will show after pressing
"OK" button, press "OK" again to restore the
default setting.
Page 14