Qilive Q.5870 Manuel D'utilisation page 12

6.1.2. REPLACING THE DUST BAG
EN
Empty or replace the dust bag when the "Dust bag full" indicator (3) turns red, or when it
is half-full but there is a loss in suction power.
11
12
6.2. MOTOR FILTER
The motor filter should be replaced after every 5 dust bags. In between, the filter can be
cleaned.
13
1. Turn off and unplug the vacuum cleaner.
2. Press the Front cover release button (7) to open the
cover.
3. Hold the collar of the dust bag and gently slide it upwards
to remove it from the holding frame (Fig. 11).
4. Gently slide a new dust bag into the holding frame and
close the front cover. Do not unfold the new dust bag.
Keep it in its original folded state for easy installation and
closing of the cover (Fig. 12).
Cleaning or replacing the motor filter
1. Cleaning or replacing the motor filter
2. Turn off and unplug the vacuum cleaner.
3. To access the motor filter, press the Front cover release
button (7) to open the cover.
4. Remove the dust bag.
5. Slide the filter holder (24) upwards to remove it (Fig. 13).
a) Detach the motor filter (23) from the filter holder (24)
and rinse them under the tap with lukewarm water
(Fig. 16). Allow to air dry for 24 hours (Fig. 17) before
inserting them back into the vacuum cleaner.
b) Or, remove the motor filter (23) from the filter holder
(24) and discard it. Attach a new motor filter to the
filter holder (24), and insert them back into the vacuum
cleaner.
12