AquaScape ULTRAKLEAR 1000 Instructions Et Entretien page 9

4. push ballast into the outer fixture tube and rotate
clockwise to lock it into position. push the latch tab back
into place to lock the ballast in position.
replaCing Or Cleaning
the internal Swirl SleeVe
the swirl sleeve inside the ultraKlear
the efficiency of ultraKlear
®
time with the uV lamp. the swirl sleeve can be removed for
cleaning or replaced if needed.
1. remove the ballast as shown earlier and pull the uV light
and quartz sleeve out of the ultraKlear
2. the swirl sleeve(s) can now be pulled free from the outer
tube. you may need to tap the end of the outer tube into
your palm to dislodge the tube.
3. with the swirl sleeve fully removed it can either be cleaned
or replaced.
www.aquascapeinc.com | ☎
housing increases
®
by increasing the waters contact
housing.
®
CAN 1-866-766-3426 | ☎
4. if inserting more than one swirl sleeve into the
ultraKlear housing (28w and 55w fixtures), the
®
individual swirl sleeves snap together. NOTE: The
swirl sleeves are not designed to be dismantled
once they are connected together.
US 1-866-877-6637
9