AquaScape ULTRAKLEAR 1000 Instructions Et Entretien page 5

• an optional 2-way flow
control Valve (#88005) can
be used to make sure the
water flow does not exceed
the ultraKlear Maximum flow
®
rate. please refer to the ultraKlear
specification chart included in
this manual for maximum flow rate
recommendations.
• aquaforce solids-Handling
®
waterfall pump is ideal for use with
the ultraKlear – the aquaforce
®
pre-filter cage allows
for the pump to be
submerged directly in
the pond and improves
uV efficiency by
pre-filtering the larger
debris from reaching
the ultraKlear . other
®
in-pond pump makes
and models can also
be used.
• the ultraKlear is designed to be located outside the
®
pond. we recommend placing it in a location that is easy
to hide and access for maintenance. the ultraKlear
can be attached to a board and set on level ground or
mounted using the four screw holes in the support saddles
as shown here.
• the ultraKlear includes three plumbing ports:
®
- in – pipe from pump (can use either end port
as pond water "in").
- out – pipe back to pond (use opposite end
port for discharge back to pond).
- optional inlet/outlet to assist with installation
and pipe routing.
www.aquascapeinc.com | ☎
®
2-Way Flow Control Valve
®
AquaForce Pond Pump
®
®
CAN 1-866-766-3426 | ☎
• the 90º elbow fittings and locking rotational ball fittings
allow 360º directional movement to accommodate the
plumbing configuration desired or the Multi-Hose adapters
can be mounted directly onto the ultraKlear
shown below.
Multi-Hose Adapters mounted
directly to UltraKlear
®
• fittings should be hand-
tightened only and be
installed with the flat
rubber gaskets to achieve
leak-free seals.
NOTe: Do not use tools
to attach the fittings.
US 1-866-877-6637
Optional Inlet/Outlet
Pond Water IN
®
UltraKlear with Rotational Ball
®
fittings and Multi-Hose Adapters
Rotational Ball fittings
Treated Water OUT
fixture as
5