Dustbane 19679 Manuel De Pièces Et D'opérations page 4

Adjustments
The manual sweeper is factory-adjusted for the operation on plane and smooth ground.Therefore, you only need to bring the lateral
brush to the operating position. As a rule, brushes should be adjusted so as to touch the ground with a light pressure.
To adjust the worn main sweeping roll or to use the machine on a non-fl at ground, simply rotate the wheel (Picture 4 pos. 1)
clockwise or counterclockwise to the requested height.
N.B.: A clockwise (+) rotation of the wheel lowers the brush to the oor; a counterclockwise (-) rotation lifts it.
N.B.: Before adjusting the central brush, some models require the loosening of the collar (Picture 4 pos. 2). After adjusting, tighten hard.
To adjust the lateral brush, simply lift it to the rest position and rotate the rubber element (Picture 5 pos.1) clockwise or
counterclockwise by hand after releasing the collar (Picture 5 pos. 2).
N.B.: Like the above-mentioned brush, a clockwise rotation lowers the lateral brush, while a counterclockwise rotation lifts it.
Use
Simply push the manual sweeper on the fl ooring where there is dirt to eliminate.
N.B.: Remember that the number of revolutions of sweeping rolls (thus, e ciency) depends on the speed of travel.
ATTENTION: Strings, wires, packing tapes and objects with similar lengths should be collected by hand. Remove them if they get
rolled onto the brushes
4