LENCO BTT-9 Mode D'emploi page 11

AUDIO OPERATION
Use the 3.5mm-RCA Audio cable (included) to connect the unit with Disc player/MP3
player/phone/computer or other music device.
1. Connect one end of the Audio cable to the R/L Audio-in Jack on the back panel of
the unit, then connect the other end to the MP3 player.
2. Press the MODE
remote to switch to Aux in mode (Aud-1/Aud-2).
3. Press the AUX1/2 button to enter the Aud-1 mode and start playback by the
device connected to the R/L RCA Jack.
4. Press the AUX1/2 button to enter the Aud-2 mode and start playback by the
device connected to the 3.5mm Aux in Jack.
Disc player
FM OPERATION
1. Adjust the FM antenna to get the best reception.
2. Press the MO/ST button to turn stereo on.
3. Press the MODE
4. Press the /
5. Press the /
6. Press and hold the
7. Press the SEARCH button on the remote control or
press again to stop searching.
8. Save (60) stations:
Press the NUMBER buttons to select the preset number, then press the F button and
input the frequency, at last press the SAVE button to save the station.
E.g. to save the 107.5MHz into preset 36. Press the NUMBER button 10+, 6, then
press F and input 1, 7, 5, 0, at last press the SAVE button.
button on the top panel or press the AUX1/2 button on
button to switch to the FM mode.
button to skip to the previous or next station.
button on remote to tune the frequency by 0.05MHz.
/ button on remote to skip to strongest station.
FM antenna
MP3 player
on unit to search the stations,