Bluetooth Operation; Usb Operation - LENCO BTT-9 Mode D'emploi

BLUETOOTH OPERATION

1. Press the MODE
2. The previous paired device will connect to speaker tower automatically when each
time changing to Bluetooth mode.
3. Turn on the Bluetooth device (e.g. phone) and enter the Bluetooth search interface.
4. Search "BTT-9" and pair it, input the password "0000" if necessary. If paired, the
display will blink steadily.
5. If it still doesn't work, reset the Bluetooth and follow above steps again.
NFC OPERATION
1. Press the MODE
2. Place the back of phone (with NFC function) on the position of word "NFC" on the
front panel of the unit for 3 seconds, the Bluetooth function of the phone is activated
automatically.
3. When the indicator lights steadily and you can hear an audible signal, they are paired.
4. To disconnect NFC Bluetooth connection, place the back of the phone on the position
of the word "NFC" on the front panel of the unit. When there comes an audible
signal, they are disconnected.
5. Some devices of Android system 4.0 or below need to install the NFC.apk to enable
the NFC function. Some devices may be in a weak compatibility for NFC function, that
may relate to the NFC software.

USB OPERATION

1. Power on the unit and insert a USB Flash Drive (not supplied) into the USB Port,
ensuring the plug is fully inserted at the correct way.
2. Press the MODE
3. The tower will play music from the USB automatically.
4. The maximum size of Flash Drive that can be connected is 32GB max.
5. The supported format for USB play is MP3.
button to switch to the Bluetooth mode.
button to enter the Bluetooth mode.
NFC sensor
button to switch to the USB mode.
Phone with NFC
US B