S&P SILENT Serie Mode D'emploi page 13

ENGLISH
SILENT AXIAL EXTRACTOR FANS
The installation and settings must be
done only by a Qualifi ed Electrician.
The SILENT extractor fan range is
manufactured to the high standards
of production and quality as laid down
by the international Quality Standard
ISO 9001. All components have been
checked and every one of the fi nal
products will have been individually
tested at the end of the manufacturing
process.
On receipt of the product we recom-
mend that you to check the following:
1. That it is the correct model.
2. That the details on the rating label
are those you require: voltage, fre-
quency...
The installation must be carried out in
accordance with the electrical stand-
ards in force in your country.
INSTALLATION
IMPORTANT: Before installing and
wiring the unit, ensure that the main
supply is disconnected.
Fig. 1:
1. Protection grille
2. Connection terminals
3. Outlet with backdraught shutter
4. Cable entry
The SILENT is suitable for wall or ceil-
ing mounting and can either discharge
directly to the outside or via an individ-
ual ducting system (see Fig. 2).
The unit can be mounted on the wall
or ceiling using the 4 rubber blocks
and the screws provided.
Make a hole in the wall or ceiling of
diameter:
– SILENT-100: 105 mm.
– SILENT-200: 125 mm.
– SILENT-300: 160 mm.
If the unit is to be installed with indi-
vidual ducting, use a standard duct of
diameter:
– SILENT-100: 100 mm
– SILENT-200: 125 mm
– SILENT-300: 150/160 mm.
Ensure that there are no obstructions
to the airfl ow and that the impeller
turns freely.
Fix the extractor to the wall in such a way
that it is not distorted in order to avoid
noise generation or problems with the
rotation of the impeller. Make sure that
the backdraught shutter opens freely
and has not being damaged in transit.
Introduce the mains cable through the
cable entry (4) and fi x it to the wall.
Connect the electrical wiring as set
out below and then mount the protec-
tion grille (1).
ELECTRICAL CONNECTION
The SILENT is an extractor designed
for a single phase supply, with volt-
13