DeWalt XR LI-ION DCB090 Traduction De La Notice D'instructions Originale page 46

EN G LI S H
• In case of damaged power supply cord the supply cord must be
replaced immediately by the manufacturer, its service agent or
similar qualified person to prevent any hazard.
• Disconnect the charger from the outlet before attempting any
cleaning. This will reduce the risk of electric shock. Removing
the battery pack will not reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard 230 V
household electrical power. Do not attempt to use it on any
other voltage. This does not apply to the vehicular charger.
SAVE THESE INSTRUCTIONS
Chargers
The DCB105 charger accepts 10.8 V, 14.4 V and 18 V Li-Ion (DCB121,
DCB123, DCB125, DCB140, DCB141, DCB142, DCB143, DCB180,
DCB181, DCB182 and DCB183) battery packs.
This charger requires no adjustment and is designed to be as easy as
possible to operate.
Charging Procedure (fi g. 2)
1. Plug the charger (f) into an appropriate 230 V outlet before
inserting the battery pack.
2. Insert the battery pack (a) into the charger, making sure the pack
is fully seated in the charger. The red (charging) light will blink
continuously indicating that the charging process has started.
3. The completion of charge will be indicated by the red light
remaining ON continuously. The pack is fully charged and may be
used at this time or left in the charger.
NOTE: To ensure maximum performance and life of Li-Ion batteries,
fully charge the pack before first use.
Charging Process
Refer to the table below for the state of charge of the battery pack.
44