DeWalt XR LI-ION DCB090 Traduction De La Notice D'instructions Originale page 45

cavities. Always unplug the charger from the power supply
when there is no battery pack in the cavity. Unplug charger
before attempting to clean.
• DO NOT attempt to charge the battery pack with any chargers
other than the ones in this manual. The charger and battery
pack are specifically designed to work together.
• These chargers are not intended for any uses other than
charging D WALT rechargeable batteries. Any other uses may
E
result in risk of fire, electric shock or electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting charger.
This will reduce risk of damage to electric plug and cord.
• Make sure that cord is located so that it will not be stepped
on, tripped over or otherwise subjected to damage or stress.
• Do not use an extension cord unless it is absolutely necessary.
Use of improper extension cord could result in risk of fire, electric
shock or electrocution.
• When operating a charger outdoors, always provide a dry
location and use an extension cord suitable for outdoor use.
Use of a cord suitable for outdoor use reduces the risk of electric
shock.
• Do not block the ventilation slots on the charger. The
ventilation slots are located on the top and sides of the
charger. Place the charger in a position away from any heat
source.
• Do not operate the charger with damaged cord or plug —
have them replaced immediately.
• Do not operate charger if it has received a sharp blow, been
dropped or otherwise damaged in any way. Take it to an
authorised service centre.
• Do not disassemble the charger; take it to an authorised
service centre when service or repair is required. Incorrect
reassembly may result in a risk of electric shock, electrocution or
fire.
E NGLI SH
43