SNOWJOE 24V-SS13-CT Manuel D'utilisation page 9

When to Charge the iON+ 24V
Lithium-iON Battery
NOTE: The iON+ 24V lithium-ion battery packs do not develop
a "memory" when charged after only a partial discharge.
Therefore, it is not necessary to run down the battery pack
before inserting the charger plug.
• Use the battery charge indicator lights to determine when to
charge your iON+ 24V lithium-ion battery pack.
• You can "top-off" your battery pack's charge before starting
a big job or after a long day of use.
Charging the Battery
1. Press the push lock buttons on the battery to pull the
battery pack out of the equipment (Fig. 1).
Fig. 1
Push lock button
2. Depending on your Snow Joe
how to recharge your lithium-ion battery will vary. You may
either insert your 24-volt battery into the 24VCHRG-QC
Quick Charger (sold separately) or the 24VCHRG-DPC
Dual Port Charger (sold separately) (Figs. 2 – 3).
Fig. 2
Charging
red
24VCHRG-QC
quick charger
(Sold separately)
Fully
Charged
green
+ Sun Joe charger model,
® ®
Battery pack
Fig. 3
Charging
red
Fully
Charged
green
3. The battery indicator LEDs will illuminate one by one
during the charging process. Unplug the charger
immediately when the 3 LEDs are all illuminated.
4. The 24VCHRG-QC Quick Charger (sold separately) and
the 24VCHRG-DPC Dual Port Charger (sold separately)
are also equipped with additional charging indicating
lights which will indicate the charging status (Figs. 2 – 3).
m
CAUTION!
FIRE HAZARD. When disconnecting the
charger from the battery, be sure to unplug the charger from
the outlet first, then disconnect the charger from the battery.
m
WARNING!
This charger does not automatically turn off
when the battery is fully charged. Please take care not to leave
the battery plugged into the charger. Switch off or unplug the
charger at the mains when charging is complete.
5. Timely recharging of the battery will help prolong the
battery's life. You must recharge the battery pack when
you notice a drop in the equipment's power.
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the battery.
6. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger.
Assembly
Connecting the Poles
1. Connect the upper pole assembly with the middle pole
assembly. Align the screw holes (Fig. 4).
9
Battery pack
24VCHRG-DPC
dual port charger
(Sold separately)