Spector&Co SPECTECH T112 Mode D'emploi page 2

Behind linepad:
To Charge T112
1. Connect the micro USB output of a charging cable provided into the T112 & connect the USB output to the wall
adapter (not included)
2. The blue LED will flash in succession to indicate that the T112 is being charged (all 4 LED lights will light up
when the T112 is fully charged
3. Charging will stop automatically when the T112 is fully charged
Note: To verify remaining battery power of T112, press power button:
4 blue LED indicates 100 – 75% battery power remaining
3 blue LED indicates 75 – 50% battery power remaining
2 blue LED indicates 50 – 25% battery power remaining
1 blue LED indicates 25 – 0% battery power remaining
To charge electronic devices using the T112
1. Connect the USB cable accessory that is compatible with your smart phone/electronic device and insert USB
output into T112
2. Press power button
3. Blue LED light will remain lit while your device is being charged
4. Charging will stop automatically when the electronic device is fully charged
USB output port
Back of portfolio:
LED lights
Power ON/OFF Button
Power Icon
Micro-USB input port