PSC SP Ace Guide De L'utilisateur page 21

All manuals and user guides at all-guides.com
W
Make a copy of the mounting template on the next
1
page and tape it where you will mount the scanner.
2 Drill two 3/32" (2.4mm) pilot holes for the mounting
screws.
3
Install the two pan-head screws from the mounting
hardware kit leaving 1/8" (3.2mm) space between
the wall and the screw head.
Attach the power and interface cables to the scanner.
4
Be sure to tighten the screw that secures the inter-
face cable to the scanner. Route the cabled as
shown.
Do NOT connect cables to power or terminal at this
time.
Remove and discard the keyhole covers.
5
Install the scanner over the two screw heads (A).
6
Slide the scanner down approximately 1/2"
(12.7mm) (B) to lock it in place.
Proceed to the instructions titled Connecting the
Scanner and Power-Up Procedure to complete the
installation.
R44-1132
M I
ALL OUNT NSTALLATION
I
NSTRUCTIONS
17