Controls - PSC SP Ace Guide De L'utilisateur

All manuals and user guides at all-guides.com
C
ONTROLS
The operator switch has three functions: wake-up the scanner (exit
Sleep Mode), enter Programming Mode and Volume Selection.
W -U S
AKE P CANNER
If green lamp is flashing slowly, the scanner is in Sleep Mode.
Pressing and releasing the switch quickly (within three seconds) will
wake the scanner up and return it to normal operation. This feature
is a back-up to the motion sensor's automatic wake-up function.
E P
NTER ROGRAMMING
Programming describes the process of changing scanner features
using the special barcode labels contained in the Programming
Guide (R44-1140). When the scanner is placed in Programming
Mode, the scanner will not read any standard barcode labels or
transmit any data to the host.
Pressing and holding the switch until you hear a tone and then
releasing the switch before a second tone sounds places the scanner
in Programming Mode. The indicator lamp will flash continuously
two times per second until you exit Programming Mode.
The Programming Guide contains a description of Programming
Mode and complete instructions for customizing your scanner's
features.
V S
OLUME ELECTION
Enter Volume Selection by pressing and holding the switch longer
than eight seconds until a second tone sounds. The second, alternate
tone indicates that the scanner has entered Volume Selection. The
scanner will cycle through the four volume selections sounding each
one three times. Press the switch immediately after the desired
volume has sounded to select that volume. Removing power from
the scanner causes this setting to be forgotten. To change and keep
this setting, you must use the barcode labels in the Programming
Guide.
6
O
PERATOR
M
ODE
S
WITCH
SP*ACE User's Guide