Black & Decker DR260 Mode D'emploi page 9

Drilling In Wood
Holes in wood can be made with the same twist drill bits used for metal or with spade bits.
These bits should be sharp and should be pulled out frequently when drilling to clear chips
from the flutes.
Drilling In Metal
Use a cutting lubricant when drilling metals. The exceptions are cast iron and brass which
should be drilled dry. The cutting lubricants that work best are sulfurized cutting oil or lard oil.
problem
• Unit will not start.
For assistance with your product, visit our website www.blackanddecker.com for
the location of the service center nearest you or call the BLACk+DeCkeR help line at
1-800-544-6986.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFeTY and ReLIABILITY, repairs, maintenance and
adjustment should be performed by authorized service centers or other qualified service
personnel, always using identical replacement parts.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or
authorized service center. If you need assistance regarding accessories, please call:
1-800-544-6986.
WARNING:
The use of any accessory not recommended for use with this tool could
be hazardous.
SERVICE INfORMATION
All BLACk+DeCkeR Service Centers are staffed with trained personnel to provide
customers with efficient and reliable power tool service. Whether you need technical
advice, repair, or genuine factory replacement parts, contact the BLACk+DeCkeR
location nearest you. To find your local service location, call: 1-800-544-6986 or visit
www.blackanddecker.com
Troubleshooting
possible Cause
• Cord not plugged in.
• Forward/reverse slider not fully
depressed in desired direction.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
9
possible Solution
• Plug tool into a working
outlet.
• Push slider completely to
the left or right.
• Replace circuit fuse.
(If the product repeatedly
causes the circuit fuse to
blow, discontinue use
immediately and have it
serviced at a
BLACk+DeCkeR
service center or
authorized servicer.)
• Reset circuit breaker.
(If the product repeatedly
causes the circuit breaker
to trip, discontinue use
immediately and have
it serviced at a
BLACk+DeCkeR
service center or
authorized servicer.)
• Have cord or
switch replaced at
BLACk+DeCkeR
Service Center or
Authorized Servicer.