Smart Key Bracelet; Energy Saving Modes - BH FITNESS ATOMX Manuel

EN
USER MANUAL
C) They lose their charges naturally and gradually with use. The battery can be fully discharged (100%)
approximately 500 times, with maximum battery deterioration of 20%. In the case of partial discharges, only the
discharged part is counted. For example, if we charge the battery every time its charge level falls by 25%, we will
be able to charge it to 100% of its initial capacity 2,000 times.
In short, the guaranteed durability of the battery with maximum degradation of 20% is at least 20,000 km.

5.2 Smart Key Bracelet

To make it easier to open and remove the battery, a "Smart Key
Bracelet" is supplied with it. This is a water-resistant bracelet that
requires no battery. It is encrypted to only work with your battery.
To open the lock, the user turns off the control panel and holds
the bracelet at a short distance (approx. 1 cm) from the location
marked on the battery and, after 1 second, the system carries out
an ID check and beeps before starting the lever opening process.
The bracelet will not open the lock if the control panel is switched on.
To open it, the user must first turn off the control panel.
The bracelet will not work if the battery is fully discharged.
ADVERTENCIA
Your battery must have more than 1% capacity for it to work.
When the lever is open, the user can remove the battery by pulling it out towards the down tube.
5.2.1 Security Smart Key.
By coding the control panel (Settings/Start-up profile), the user
can add an additional security function. If the Security Smart Key
function is activated, the control panel will display a padlock when
it is switched on. The user holds the bracelet at a short distance
from the location marked on the battery and the lock on the display
panel's display disappears, providing full access to all of the
features.
48
ATOMX ATOMX

5.3 Energy Saving Modes

The battery has been designed to ensure a long service life. This is possible thanks to the energy saving modes:
5.3.1 Transport Mode (only during the first use)
In order to minimise internal consumption while transporting the bicycle from the factory to the store, the battery
is in Transport mode.
The user can finally exit this Transport mode by charging the battery to 100% before its first use.
ATTENTION
5.3.2 Stand By Mode
In order to minimise internal consumption, the battery automatically switches to Stand By mode. This happens
automatically when the system detects no charging, no discharging and no communication with the battery for
a period of 10 minutes. So, for example, this mode will automatically turn off the display panel after 10 minutes
without use, if the user has left it on after parking.
The user can exit this Stand By mode by simply turning on the bicycle's display panel.
5.3.3 Deep Sleep Mode
In order to protect the battery during long periods of inactivity or storage (for example, during the winter),
the battery automatically switches to Deep Sleep mode.
This happens automatically when any of the following situations occur:
A) If the charge level of the battery is below 1%, the battery goes into Deep Sleep mode when the battery
has continuously been in Stand By mode for 10 minutes.
B) If the charge level of the battery is below 10%, the battery goes into Deep Sleep mode when the battery
has continuously been in Stand By mode for 48 hours.
C) If the charge level of the battery is below 40%:Deep Sleep mode is activated when the battery has
continuously been in Stand By mode for 14 days.
D) If the charge level of the battery is below 80%:Deep Sleep mode is activated when the battery has
continuously been in Stand By mode for 30 days.
The user can exit this Deep Sleep mode by holding down the battery's SOC button (which
checks the charge level) for 5 seconds or starting to charge the battery with the charger.
If the battery does not charge fully, the Transport mode will not deactivate,
repeatedly entering this mode quickly for its protection.Remember to fully
charge the battery to finally deactivate the Transport mode.
Pressing SOC button 5 sec
2 flashes of all LEDs Stand By Mode
1 flash of all LEDs Deep Sleep Mode
EN
USER MANUAL
49