Display Panel; Overview Of The Display Panel; Display Panel Operation - BH FITNESS ATOMX Manuel

EN
USER MANUAL

4. DISPLAY PANEL

4.1 Overview of the Display Panel

Central Display Panel with a screen located in the centre of the handlebar, with a remote control located on the
left side of the handlebar:
1. POWER button.
2. (+) button.
3. (-) button.
4. Lights indicator.
5. Bicycle instant speed indicator.
6. Pedal assistance mode indicator colour.
7. Range indicator.
8. Battery level indicator.
9. Bicycle secondary information indicator.
10. Bluetooth indicator, Ant+, lights and error
2
3
1
Remote Control
The range is calculated based on the riding conditions during the last
NOTE
kilometre and the remaining capacity of the battery.

4.2 Display Panel Operation

4.2.1. Switching the Pedal Assistance System On and Off
The pedal assistance system is turned on by holding down the POWER
button for 3 seconds. The pedal assistance system is turned off by holding
down the POWER button again for 3 seconds.
The bicycle can be used normally without any type of assistance.
After turning the system on, make sure that you do not start riding without
checking the assistance mode. By default, it starts with the assistance mode
WARNING
selected before it was last switched off.
Wait for 3 seconds after turning on the system before you start applying
pressure on the pedals. During this 3-second period, the assistance system is
starting up and calibrating the torque sensor. Otherwise, if you press the pedal
NOTE
beforehand, this may weaken assistance and error 14 may even be displayed
on the screen (see Troubleshooting section). To fix this, you should reboot the
system without applying pressure on the pedals for a period of 3 seconds.
38
ATOMX
10 5
4
8
7
9
6
Central Screen
3 sec
ATOMX
4.2.2 Pedal Assistance Mode Selection
The system has 5 pedal assistance modes:
AUTO Identified by the Maroon Colour. Use when you want to obtain gradual power,
according to the user's torque or heart rate.
Identified by the Red Colour. Use when you want to get maximum power from the
BOOST
system.
Identified by the Orange Colour. Use when climbing difficult terrains.
SPORT
Identified by the Blue Colour. Use when you want a more comfortable ride, e.g.
ECO +
when climbing a steep hill.
ECO Identified by the Green Colour. Use when you want to travel as far as possible.
NO ASSIST Identified by the Black Colour. Use when you want to travel without assisted power.
You can continue to use the other functions of the display panel.
To toggle through the assistance modes, the user must press the (+) button to increase the level of assistance
and the (-) button to reduce the level of assistance.
Instant Power Options
During a journey, selecting suitable assistance modes for the terrain and
NOTE pedalling conditions that you encounter will ensure the best balance between
battery economy and pedalling comfort.
4.2.3 Turning the Bicycle Lights On and Off.
Holding down the (-) button for 3 seconds will turn the backlighting of the
display panel on and off. The lights will also be switched on and off in those
models equipped with a battery-powered light system. At this moment, the
lights on indicator will appear on the screen:
EN
USER MANUAL
3 sec
39