Publicité
Les langues disponibles
Les langues disponibles
1
You cannot fully dim the light of the cooking mode,
because then there will not be sufficient light to cook.
After having switched off the cooking mode, the last set value
will always be remembered. This means your preference will be
used every time the hood is switched on.
Mood mode
The mood mode provides optimum lighting for creating a nice
atmosphere. This mode has by default a lower light intensity
than the cooking mode.
Lighting - ambience mode
Switching ambience mode on
Select control key
.
The LED above the symbol lights up.
Confirm ambience mode
Briefly press the control key
For confirmation, you can see the LED above
the symbol flashing quickly for a short period.
The ambience mode is then fully activated and
the following functions can be changed.
Switch ambience mode on and off
Switching ambience lighting fully on and off
can be achieved by briefly pressing the
control key.
Mood mode light intensity
The brightness of the lights in ambience mode
can be increased or decreased using the
and
buttons; by holding these down, the
brightness will change.
Change the colour temperature in the
mood mode
The colour temperature can be adjusted from
cool to warm using the
Holding the keys down will adjust the colour
temperature. Release when the desired colour
temperature has been reached.
After having switched off the mood mode, the last set value
will always be remembered. This means your preference will be
used every time the hood is switched on.
.
or
or
control keys.
2.4 Remote control
The remote control for hood is preinstalled and ready for use.
Indien de ingestelde code stoort met andere
zenders, kan er een andere code op de afstands-
bediening gekozen worden. Er zijn totaal 10 code
mogelijkheden.
Change the code of the remote control
• First ensure the power supply is disconnected from your
extraction hood.
• To change the code, you must click the cover loose with a
screwdriver.
• Briefly press on the small button with a paper clip.
The 3 lights on the remote will flash the same amount of
times as the pre-set code.
• If a different code is required, press the small button for
3 seconds (the 3 lights will light up for 7 sec). Now briefly
press the small button again within 7 seconds to change the
code. (1x flash is code 1, 2x flash is code 2, etc.
There are 10 codes).
• Ensure the power supply is reconnected to the extraction
hood.
• Within 1 minute, press the
mote control.
Change the batteries
• For changing the batteries unscrew the plastic cover, remo-
ve the old batteries and insert the new ones. Pay attention
to the polarity marking given in the battery compartment.
• Empty batteries are not to be disposed of in the household
refuse, but they are to be handed in as chemical waste.
– 16 –
ON/OFF button on the re-
Publicité
