Operation; Storage/Winterizing - Pulsar 79214 Manuel Du Propriétaire

TABLE I - RECOMMENDED FUSING AND WIRING DATA
NOTICE: 79214 pumps use 60 Cycle current only.
Motor Branch Fuse
HP Rating Amps*
79214 Model:
1 20/15
(*) Time delay fuses are recommended instead of standard fuses in any motor circuit.
OPERA TION
NOTICE: NEVER run pump dry. Running pump dry
may damage seals, causing leakage and flooding.
Fill pump with water before starting motor.
Hazardous suction.
Can trap hair or body
parts, causing severe
injury or death.
Do not block suction.
Do not operate system
with broken or missing
drain covers.
suction and discharge valves are opened.

Storage/Winterizing:

NOTICE: Allowing pump to freeze will damage pump
and void warranty!
NOTICE: Do not use anti-freeze solutions (except
propylene glycol) in your pool/spa system. Propylene
glycol is non-toxic and will not damage plastic system
components; other anti-freezes are highly toxic and may
damage plastic components in the system.
Max Load Voltage/
Amps Hz/Phase
12.6/6.3 115/230/60/1 12(2)/14(2) 10(2)/14(2)1010(2)/14(2)
6
body may cause severe or
fatal injury. Small children
using pool must ALWAYS
have close adult
supervision.
Priming Pump
Release all air from filter
and piping system: see
filter owner's manual.
In a flooded suction
system (water source
higher than pump), pump
will prime itself when
Serv. to Motor - Dist. in Ft. (M)
0-100' 101-200' 201-300'
(0-30) (30-60) (60-90)
Do not block pump
suction. To do so with