Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
READ THIS MANUAL
CAREFULLY!
The PULSAR SYSTEM Series pump:
Table of Contents
Safety Instructions ......................................................2
Installation ................................................................3-4
Electrical ...................................................................4-6
Operation.....................................................................6
Storage/Winterizing ..................................................6-7
Pump Service ...........................................................7-8
Troubleshooting Guide.................................................9
Repair Parts List ........................................................10
Warranty ....................................................................11
IMPORTANT SAFETY
INSTRUCTIONS
Always follow basic safety precautions with this
equipment, including the following.
To reduce the risk of injury, do not
permit children to use this product unless they are
closely supervised at all times.
This pump is for use with permanently
installed pools and may also be used with hot tubs
and spas if so marked. Do not use with storable
pools. A permanently installed pool is constructed in
or on the ground or in a building such that it cannot
be readily disassembled for storage. A storable pool
is constructed so that it may be readily disassembled
for storage and reassembled to its original integrity.
SAVE THESE
INSTRUCTIONS
READ AND
FOLLOW SAFETY
INSTRUCTIONS!
This is the safety alert symbol. When you see this
symbol on your system or in this manual, look for
one of the following signal words and be alert to the
potential for personal injury.
warns about hazards that will cause death,
serious personal injury, or major property damage if
ignored.
warns about hazards that can cause death,
serious personal injury, or major property damage if
ignored.
warns about hazards that will or can cause
minor personal injury or property damage if ignored.
NOTICE indicates special instructions not related to
hazards.
Carefully read and follow all safety instructions in
this manual and on equipment. Keep safety labels in
good condition; replace if missing or damaged.
Incorrectly installed or tested equipment
may fail, causing
severe injury or property damage.
Read and follow instructions in owner's manual when
installing and operating equipment. Have a trained pool
professional perform all pressure tests.
1. Do not connect system to a high pressure or city
water system.
2. Use equipment only in a pool or spa installation.
3. Trapped air in system can cause explosion. BE SURE
all air is out of system before operating or testing
equipment.
Before pressure testing, be sure to follow the safety
checks listed below:
• Check all clamps, bolts, lids, and system accessories
before testing.
• Release all air in system before testing.
• Tighten trap lids to 30 ft. lbs. (4.1 kg-m) torque for
testing.
• Water pressure for test must be less than 25 PSI (7.5
kg/cm
2
).
• Water Temperature for test must be less than 100
o
(38
C).
• Limit test to 24 hours. After test, visually check
system to be sure it is ready for operation. Remove
trap lid and retighten hand tight only.
2
o
F.
Publicité
Chapitres
Table des Matières
