JessEm Tool MITE-R-SLIDE II Manuel Du Propriétaire page 7

STEP 10:
Take the Right Hand Stop Base, (Part # 22) and slide it into the t-track on the top of your fence. See Figure 12.
STEP 11:
You will want to have the stop sitting flush with the right edge of your fence. See Figure 13. Tighten the
1/4-20 x 5/8" stainless steel cap screws Part #7 with the provided 3/16" hex key.
STEP 12:
Slide the Left Hand Stop (Part #17) into the t-track on the
left side of the fence. See Figure 14.
FIGURE 12
STEP 13:
Slide the Mite-R-Slide II along the router table fence to where you
would desire the end of cut to be. This is to ensure the fence goes
all the way past the cutter if you are working on the edge of a board
or at some point before this for blind cuts.
Slide the Left Hand Stop along the track until it meets the rollers on
the Mite-R-Slide II roller base. See Figure 15. Tighten the 1/4-20
x 5/8" stainless steel cap screws Part #7 with the provided 3/16"
hex key.
FIGURE 15
7
FIGURE 13
FIGURE 14