JessEm Tool MITE-R-SLIDE II Manuel Du Propriétaire page 6

The end closest to the front of the router table (away
from your router table fence) should be riding along
the table surface. There is a UHMW wear strip (Part
#1) under the fence at this point. See Figure 11.
ALL OF THE CALIBRATIONS FOR THE MITE-R-SLIDE II ARE DONE INNFACTORY
PRIOR TO SHIPPING, HOWEVER, TO BENSURE NOTHING HAS BEENNBUMPED
OUT OF ADJUSTMENT YOU WILL WANT TO STOP AT THIS POINT AND CHECKCK
ALL OF THE FACTORY CALIBRATIONS AS FOLLOWS:
1) Checkkfor anyyvertical movement in the Rollers ((Part #18)) when on the router table ffence.
See Page 11.
2) Checkkthat the Mite-R-Slide II Indicator Block (Part #36)) is in line with the gauge at
0°° and 45°°. See Page 10.
3) Checkkthe Mite-R-Slide II ffence (Part #4))to ensure it is accurate to 90°°and 45° to the
router table fence. See Page 8 and 9.
Ifyyou find any of the above, please go to the noted page numbers and ffollow the instructions
to make anyyfine adjustments.
Any offthe adjustments can be made after assemblyyis completed, but it is a little easier while
the stops are not on the router table fence.
Once you have checked all offthe calibrations, proceed to Step 10.
You should have a very slight gap (about 1/64" to 1/32")
between your table top surface and the Mite-R-Slide II
Fence at the point closest to the router table fence. See
Figure 10.
FIGURE 10
6
FIGURE 11