JessEm Tool MITE-R-SLIDE II Manuel Du Propriétaire page 5

MOUNTING THE MITE-R-SLIDE II TO YOUR JESSEM ROUTER TABLE FENCE
STEP 7:
Slide the gauge and roller assembly put together in Step 5 and Step 6 onto the fence. Ensure the retaining bolt
(Part #25) on the bottom of the roller assembly slides into the t-slot on the top of the fence. See Figure 5 and
Figure 6.
STEP 8:
Take one (1) sheet of regular sized paper and fold it in
half, and then in half again so it has a thickness of four (4)
sheets of paper. Slide it under the fence closest to the the
Router table fence. See Figure 7.
STEP 9:
While holding the Mite-R-Slide II fence to the paper spacer
and keeping the roller mount (Part #18) with the rollers
fully engaged into the router table fence, securely tighten
the 1" stainless steel cap screws (Part #8) you installed in
Step 5 and 6. See Figure 8.
NOTE:
When adjusted correctly, your Mite-R-Slide II fence should be slightly off of the table surface closest to the
fence and riding on the table surface at the end closest to the front of the router table. See Figure 9, 10, 11.
FIGURE 5
5
FIGURE 6
FIGURE 7
FIGURE 8
FIGURE 9