JessEm Tool MITE-R-SLIDE II Manuel Du Propriétaire page 10

CALIBRATING FENCE TO "45°"
STEP A:
Using a combination square or mitre square, check to see if
the fence is at 45°. See Figure 24.
(We have used a combination square and a ruler along
the fence to check the angle)
Iffyour fence is not at 45°, follow step B, C, D and E.
STEP B:
Ensure the gauge is fully in the 45° position. See Figure 25.
STEP D:
Slide the Mite-R-Slide II fence (Part #4) further along the gauge .
See Figure 27. You will see a second set screw Part #41.
STEP C:
With the 1/8" Hex Key provided you will either loosen or tighten up
the set set screw. See Figure 23.
a) If your Mite-R-Slide II is out of square and has a gap closer to
b) If your Mite-R-Slide II is out of square and has a gap closer to
FIGURE 23
STEP C:
Loosen the Mite-R-Slide II
fence clamping knobs,
(Part #42). See Figure 26.
FIGURE 26
your router fence, you will want to tighten the set screw a little
bit. Depending on how far out it is, a quarter turn (clockwise) is
all it may need.
the front of your router table you will want to loosen the set screw
a little bit. Again, depending on how far out your Mite-R-Slide II
fence is, a quarter turn (counter clockwise) is all it may need.
10
FIGURE 24
FIGURE 25
FIGURE 27