Publicité
Les langues disponibles
Les langues disponibles
OPERATING STEAM CLEANER
„ Press the Power Button. The blue Power Indicator Light should stay
illuminated. If the light does not illuminate, check the "Troubleshooting"
section for more details.
„ The steam cleaner should take between 3-6 minutes to heat up to steam
temperatures, which will be indicated when the green Steam Ready Indicator
Light illuminates.
„ When operating the steam cleaner, make sure to keep it level during use.
Tilting the cleaner downward too far will cause water to be emitted from the
cleaner (See image to the right).
WARNING
!
For Optimal Cleaning Performance
(When using with Hoover
„ Fill the Solution Tank with the Hoover
Solution Tank" section on page 6. Turn Clean Control
For Limited Disinfection
„ Use steam alone. Do not use cleaning solution. Turn Clean Control
„ Use steam cleaner with hose assembly (N) and detail cleaning wand (J) with microfiber pad (L). (REF 1.1).
„ Make a minimum of 4 passes at a medium pace, 2-3 seconds per 1-2" stroke. Allow to sit for 1 minute.
REFILLING WATER DURING
OPERATION
CAUTION
!
To avoid burn injury, do not refill Water Tank before
steam cleaner has cooled completely. Use caution
when removing Water Fill Safety Cap. Even when
cap is able to be turned the steam cleaner may still
be hot, especially all metal surfaces.
„ Press Power Button to turn "OFF" and then
unplug Power Cord from wall outlet
„ Press down Steam Trigger (3.5,A) to release
pressure. When Water Tank is under pressure,
the Safety Pressure Indicator will rise above the
surface of the cap (3.6,B). When the tank is not
under pressure the Safety Pressure Indicator will
be flush or below the surface (3.6,C).
„ Wait 7-10 minutes until the Safety Pressure
Indicator has gone down, which indicates the
steam cleaner has cooled. After 10 minutes, if the
Safety Pressure Indicator has not fully dropped,
release residual pressure by pressing Steam
Trigger. Slowly start to unscrew the Water Fill
Safety Cap counter-clockwise while gently
pushing on the Safety Pressure Indicator. DO
NOT FULLY UNSCREW THE WATER FILL
SAFETY CAP AT THIS TIME. Allow steam
cleaner to cool an additional 5 minutes. After you
have ensured the steam cleaner has cooled and
pressure has been released, the Water Fill Safety
Cap should turn freely for removal. Unscrew the
Water Fill Safety Cap completely.
Do not operate steam cleaner without water in
Water Tank.
SteamPlus™ Cleaning Solution)
®
Steam Cleaning Solution as directed in "Removing and Filling
®
!
Dial to HIGH.
TM
Dial to "OFF".
TM
3.5
„ Remove any remaining
water to avoid overfilling
(3.7,D), insert Funnel*
and add 300ml (10oz)
water into the Measuring
Cup. Pour the water into
the Water Tank (3.7,E).
(Max. capacity of the tank
is 300ml (10oz). Do not
overfill the tank to allow
space to be left at the top).
„ Re-install the Water Fill
Safety Cap in a clockwise
direction and tighten until completely sealed.
„ DO NOT OVERTIGHTEN SAFETY CAP.
IMPORTANT
DO NOT ADD CLEANING SOLUTION TO
WATER TANK.
7
Correct Use
Incorrect Use
3.6
A
3.7
D
E
B
C
*Select models
Publicité
Chapitres
